Cabinet Preparation; Preparing For Installation - GE JP989 Owner's Manual & Installation Instructions

PREPARING FOR INSTALLATION

1
Positioning the cooktop
The cooktop is designed to look best when centered
in a cabinet at least 30" wide.
The exhaust vent beneath the cooktop must be
located between wall studs or floor joists so that the
ductwork may be installed properly.
At least 6" must be allowed between side edges of
the cooktop and adjacent walls.
13" max.
depth of
unprotected
30" min.
overhead
clearance from
cabinets
countertop
to unprotected
overhead
surface
" min.
1 ⁄
1
2
Avoid placing cabinets above the cooktop unit, if
possible, in order to reduce the hazards caused by
reaching over heated surface units. If cabinets are
placed over the cooktop, the risks can be reduced by
installing a range hood that projects horizontally a
minimum of 5 inches beyond the bottom of the
cabinets.
If cabinetry is used above the cooktop, allow a
minimum 30" clearance between the cooking surface
and the bottom of any unprotected cabinet.
If the clearance between the cooktop and the
cabinetry is less than 30", the cabinet bottom must
be protected with flame retardant millboard at least
1/4" thick, covered with 28 gauge sheet steel or
0.020" thick copper. Clearance between the cooktop
and the protected cabinetry MUST NEVER BE LESS
THAN 24."
EXCEPTION: Installation of a listed microwave oven
or cooking appliance over the cooktop shall conform
to the installation instructions packed with that
appliance.
A 15" minimum must be kept from the side edge of
the cooktop to the bottom of any cabinet not directly
above the cooktop. If the clearance is less than 15",
adjacent cabinets should be at least 6" from the side
edge of the cooktop.
Installation Instructions

CABINET PREPARATION

15" min. height
from countertop
to nearest
cabinet on
either side of
the unit
6" min.
clearance from
cutout to side
walls
16
2
PREPARING THE BASE CABINET
This cooktop is designed to fit easily into a variety
of cabinets. However, some cabinets may require
modifications.
Preparing a cabinet that is against a wall
In some cabinets, the sides may need to be scooped
" as shown, and the corner braces
or cut down 5 3 ⁄
4
removed in order to accommodate the unit.
In 75 cm and 90 cm frameless European cabinets,
the back panel may need to be cut down 5
accommodate the unit.
Preparing a peninsula or island-type cabinet
In a peninsula or island-type cabinet, the sides may
need to be scooped or cut down, and the corner
braces removed in order to accommodate the unit.
"
5 3 ⁄
4
Approx.
3
ROUGH PREPARATION
OF JUNCTION BOX
IMPORTANT – FOR PERSONAL SAFETY,
REMOVE HOUSE FUSE OR OPEN CIRCUIT
BREAKER BEFORE PREPARING JUNCTION
BOX.
Install an approved junction box within shaded
area shown in diagram. Junction box must be
" below top of cabinet.
at least 10 1 ⁄
2
Run conductors from residence wiring to
junction box according to local electrical codes.
9"
16"
20"
" to
3 ⁄
4
" Approx.
5 3 ⁄
4
for European
cabinets
C L
4"
"
10 1 ⁄
2