Table of Contents
Advertisement
Available languages
Available languages
8.1 Conversion end caps kit mounting
Front hub
→ Remove the pressure end caps installed
on the front hub (standard TA 12×100 mm)
and replace them with those you need
(QR 100 mm or TA 15×100 mm)
→ Install the end cap with the smaller flange
diameter (1) on the disc brake rotor side
and the one with the bigger flange diameter
(2) on the opposite side
1
4
3
→ Make sure the washer (3) is correctly placed
in its seat on the end cap (4) before inserting
caps into the hub
3
4
2
dedaelementi.com
Advertisement
Table of Contents
Need help?
Do you have a question about the ZERO2DB LTD and is the answer not in the manual?
Questions and answers