Obs To A Waypoint Not In Your Flight Plan; Flyleg - Garmin GNS 480 Pilot's Manual

Basic Operation
Direct-To
38

OBS to a Waypoint Not in Your Flight Plan

1. Press Direct-To. Press the DB smart key.
2. Select a new waypoint outside of your flight plan with the Large and Small knobs.
3. Press OBS. Now use the external CDI/HSI resolver to control the selected course. The GNS 480 will read
the OBS information and will change the course displayed on the Map displays.
4. After reaching the waypoint, the GNS 480 will continue to track outbound. You may terminate this
mode by going Direct-To any waypoint or use the FlyLeg function.

FlyLeg

With the FlyLeg Menu selection you can activate a particular leg of your flight plan. This feature allows you to
bypass a leg in your flight plan. This is useful when you are vectored onto an airway. If you have picked a leg
that cannot be activated for navigation, a message will appear to advise you. Press CLR to exit.
1. Press Direct-To.
2. Select the desired leg of your flight plan with the Large knob (the ActFP smart key is highlighted).
3. Press the FlyLeg key to activate the selected leg.
4. Continue to fly the assigned heading until the course is alive. If you are not on an assigned heading, roll
steering will fly a 45° intercept to the active leg (roll steering autopilots only).