Usb And Audio Connection; Usb Ports - Furuno NAVNET 3D MFD8/12/BB Installation Manual

When Extended Mode is used the two screens need to be located in close proximity to
each other. The two monitors show independent screen displays that can be configured
independently. Only one Keyboard is used to control both monitors (the cursor will
"jump" back and forth from monitor to monitor).
When the two monitors are installed for remote station configuration, dual keyboard
installation from one processor requires use of the Monitor "Clone" mode (in this case
both monitor will show the same picture)
Furuno offers the following DVI cable:
- 5 Meter DVI Cable (FUSA P/N= 000-149-054)
- 10 Meter DVI Cable (FUSA P/N= CBL-DVI-10M)
2.9.

USB and Audio Connection

2.9.1. USB Ports

The MFD8/12 has one USB Ver. 1.0 port and the MFDBB has two USB Ver. 2.0 ports.
These USB ports are used to connect a generic USB mouse and Keyboard. Virtually
any "off the shelf" USB mouse (wired or RF wireless but NOT Bluetooth) will work with
NavNet3D. However, in order to utilize full RotoKey functionality, you will need a mouse
that has a scroll wheel that is also "clickable" with a middle click, which will emulate
selection and confirmation of a desired RotoKey function. No loading of additional
37