Graco King E60 Operation page 18

Repair
Reinstall Reinstall Electronics Reinstall Electronics Electronics Cover
if if if removed removed to to to replace removed replace replace the
Make sure wires are not pinched when re-installing
covers. Wires will be damaged and create an
electrical hazard and/or fire and explosion hazard
if pinched.
1. Plug in all connectors. Ensure all connectors
are securely attached to the control board (see
Wiring Schematic, page
2. Secure loose motor wires into the clip inside the
housing (see Wiring Schematic, page
3. Reinstall electronics cover onto center housing.
4. Install the 12 bolts using a 6 mm hex wrench.
NOTE: Ensure the lock washers are still in place. NOTE: NOTE:
5. Torque the bolts to 15 ft-lb (20 N•m).
18
Cover onto Cover onto Driver onto Driver (only Driver (only (only
the encoder the encoder cable) encoder cable) cable)
26).
26).
Reinstall Reinstall Motor Reinstall Motor Motor Cover Cover Cover
1. Reinstall motor cover onto driver housing.
2. Install the four bolts and mounting lock washers
that hold on the motor cover using a 6 mm hex
wrench. Ensure the lock washers are still in
place.
3. Torque the bolts to 15 ft-lb (20 N•m).
4. Follow the Power Unit — Run Calibration
Procedure, page 15.
Reattach Pump Pump Lower Lower
Reattach Reattach Pump Lower
See the system manual.
3A8124A