Test Run - YASKAWA CIMR-SSA Series Instruction Manual

4.3

TEST RUN

40
(1) Digital Operator Display at Power ON
When the system is ready for operation, turn ON the power supply. Verify that the inverter
powers up properly. If any problems are found, turn OFF the power supply immediately.
The digital operator display illuminates as shown below when turning the power supply ON.
Refer tp Section 5 for operation method of digital operator.
DRIVE FWD REV
DIGITAL OPERATOR
JVOP-132
LOCAL
REMOTE
JOG
FWD
REV
RUN
Fig. 19 Digital Operator Display at Power ON
REMOTE
SEQ REF
DRIVE
DSPL
PRGM
DATA
ENTER
RESET
STOP
Mode Indicator LED :
DRIVE/REMOTE (SEQ, REF) LED ON
Display Section :
Displays frequency reference
(corresponding to analog reference value)
Operation Indicator LED :
STOP LED ON