Location Of Dip Switches, Jumper Wires On The Gyro Converter Board; Setting The Heading Readout On The Radar Display; Gyro Converter Board; Hdg Menu - Furuno 2127 Installation Manual

4. INSTALLING OPTIONAL EQUIPMENT

Location of DIP switches, jumper wires on the GYRO CONVERTER board

JP2
(Stator voltage)
JP3
(Rotor voltage)
JP1
(Gyro type)
Fuse
(2A)
J5
(Rotor signal input,
external power input)

Setting the heading readout on the radar display

Confirm that the gyrocompass is giving a reliable readout. Then, set the heading readout on
the radar display with the gyrocompass readout as follows:
1. Roll the trackball to place the arrow in the HDG box at the top right corner of the screen.
2. Push the right button on the trackball module to open the HDG menu.
3. Press the [1] key to choose the HDG SOURCE and choose AD-10.
4. Press the [2] key to choose the GC-10 SETTING option.
5. Roll the wheel to set gyrocompass reading.
6. Press the [MENU] key to close the menu.
4-8
JP5, JP4
(Supply voltage)
SW1
J4
DIP switch
(Stator signal input)
(IEC-61162-1 output port)

GYRO CONVERTER board

[HDG MENU]

1 HDG SOURCE
AD-10/SERIAL
2 GC-10 SETTING
000.0˚
HDG menu
64P1106
J8
J6
(Data output port #2)
J7
(Data output port #1)
SW3
DIP switch
J12
(Data output
port #6)
J11
(Data output
port #5)
J10
(Data output
port #4)
SW2
DIP switch
JP6, JP7
(AD format
data Tx interval)
J9
(Data output port #3)