DR 16.5 Safety & Operating Instructions Manual page 40

Chapter 6: Chipper Accessories
Shut down the Engine (The flywheel will continue to rotate for a while after the engine is shut off), Wait 5 minutes for the engine
to cool and all moving parts to come to a complete stop, remove spark plug wire and disconnect the negative battery cable before
moving or working on the chipper.
Discharge
Chute
Figure 65
Bolt and
Locknut
(2 places)
Figure 66
DR
40 ® SELF-FEEDING CHIPPER
Extended Top-Discharge Chute
Scroll
Weldment
The Extended Top-Discharge Chute enables you to better control the direction
of the discharged chips and allows you to direct them into a trailer or truck bed
for transport.
Tools Needed:

Two 1/2" Wrenches
INSTALLATION
1.
1/2" wrenches (Figure 65).
Bolts and
Locknuts
2.
3.
Locking pin on the outside (side furthest away from the hopper) (Figure 66).
4.
Extended Top-
Discharge Chute
Locking
Pin
Remove the two Bolts and Locknuts from the Discharge Chute with two
Remove the Discharge Chute from the Chipper.
Position the Extended Top-Discharge Chute onto the Chipper with the
Install the two Bolts and Locknuts and tighten with two 1/2" Wrenches.