DR 16.5 Safety & Operating Instructions Manual page 12

Wires
Figure 7
Wires
Hook Tool
Figure 8
Tow Bar
Figure 9
Tow Bar
Rear Bracket
Road Tow
Axle
Figure 10
DR
12 ® SELF-FEEDING CHIPPER
Installing the Tow Bar and Lights for the Road Tow Model
Note: For easier installation, keep the machine on the pallet and supports until the
Tow Bar is installed.
Tools and Supplies Needed:

7/16 Wrench

Two 1/2" Wrenches

Two 3/4" Wrenches

Wire strippers/Cutters

Stiff Wire with Hooked End
Tow Bar

Cable Ties (Supplied with machine)
1.
Wire Harness into the Tongue Assembly and down into the Tow Bar (Figure 7)
until they reach the large hole (Figure 8).
2.
with a small hook formed at the end.
Larger Hole
3.
the Plug end extended beyond the front of the Tongue assembly.
4.
3/8-16 x 1" Bolts and Locknuts using two 9/16" Wrenches (Figure 9).
5.
Tow Bar
Locknuts using two 9/16" Wrenches (Figure 10).
6.
to the light location over the Fender (Figure 11).
7.
to the Light location over the Fender.
8.
shown.
Base
Bolt and
Locknut
Bolt and
Locknut
Insert the ends of the Yellow/Brown and Green/Brown Wires of the
Pull the ends of the wires through the large Hole by using a stiff wire
Continue pulling the Wires through leaving approximately two feet of
Position the Tow Bar under the Base and secure the front Bracket with
Secure the rear of the Tow Bar to the Axle with 3/8-16 x 1" Bolts and
Position the Yellow/Brown Wires along the left side of the axle and up
Position the Green/Brown Wire along the right side of the axle and up
Secure the Wires under the Frame with Cable Ties at the four places
Wires
Figure 11
Yellow/
Brown
Cable Ties
Wire