Setting Data 4 To Dgps - Furuno GP-90 Installation Manual

14) Output data from the computer. When loading data is completed, the cursor shifts to
Stop.
15) Press the [ESC] key.

Setting DATA 4 to DGPS

An external DGPS receiver can be connected to the DATA 4 port.
Follow the procedure below to setup the GP-90 according to the specifications of the DGPS
receiver.
1) Press [MENU], [9] and [5].
2) Press or to select Level.
! "
3) Press or to select level; RS232C or RS422.
# $
4) Press the [ENT] key.
5) Press or to select DGPS.
# $
6) Press to select To Next Page.
"
7) Press or to select First Bit.
! "
8) Press or select first bit; MSB or LSB.
# $
9) Press to select Parity.
"
10) Press or to select parity bit; EVEN, ODD or NONE.
# $
11) Press to select Stop Bit.
"
12) Press or to select stop bit; 1 or 2.
# $
13) Press to select Baud Rate.
"
14) Press or to select baud rate; 4800 or 9600.
# $
15) Press the [ENT] key.
16) Press the [ESC] key.
DATA 4 I/O SETUP <DGPS>
To previous Page
First Bit
Parity
Stop Bit
Baud Rate
: Select
ENT: Enter MENU: Escape
Figure 5-10 DATA 4 I/O SETUP <DGPS> menu
2/2
MSB LSB
EVEN ODD NONE
1 2
4800 9600
5. INITIAL SETTINGS
17