Setting Data 4 To “Com.” (General Data) - Furuno GP-90 Installation Manual

5. INITIAL SETTINGS
Setting DATA 4 to "COM." (general data)
Waypoints and Routes data can be received from a personal computer, through the DATA
4 port.
1) Press [MENU], [9] and [5].
2) Press or to select DATA4. Level.
! "
3) Press or to select level of personal computer; RS232C or RS422.
# $
4) Press the [ENT] key.
5) Press to select Com.
$
6) Press to select To Next Page. The DATA 4 I/O SETUP <Com.> menu appears.
"
7) Press or to select Baud Rate.
! "
8) Press or to select baud rate; 4800bps, 9600bps or 19200bps.
# $
9) Press the [ENT] key.
10) Press or to select WPT/RTE.
# $
11) Press to select Command. Stop, on the same line as Command, appears in reverse
"
video.
12) Press to select Start. The message shown in Figure 5-8 appears.
$
13) Press the [ENT] key. The message shown in Figure 5-9 appears while data is being
loaded.
16
DATA 4 I/O SETUP <Com.> 2/2
To Previous Page
Baud Rate 9600 bps
L WPT/RTE
Load Data
Command Stop
Save Data WPT/RTE
Command Stop
: Select
ENT : Enter
Figure 5-7 DATA 4 I/O SETUP <Com.> menu
Loading erases current data
and stops Route navigation
Are you sure to load?
ENT: Yes MENU: No
Figure 5-8
Now loading
Waypoint/Route data !
MENU: Stop
Figure 5-9
WPT
Start
Start
MENU : Escape