Transport Brackets Height Setting; Transport Lock (Spc); Suspension (Spc) - Hardi EAGLE SPB BOOM Operator's Manual

Transport Brackets Height Setting

Hardi Commander and Explorer sprayer transport
brackets can be set in different positions to obtain
different transport heights and suitable clearance above
various tractor cabins.
For stability of the sprayer while transporting always
choose the lowest height possible.
Changing the setting of the transport brackets is to be
done in combination with adjusting the transport locks.
NOTE! The setting must be identical on both sides.
Fig 3
Transport lock (Paralift)
To change position:
1 Lift and unfold inner sections till lock is disengaged.
2 Loosen and remove the two bolts, which keep the
parts A and B assembled.
3 Reassemble A and B according to desired hole
combination.
NOTE! Always use both bolts to assemble the lock.
The setting must be identical on both sides.
NOTE! The rear settings must correspond to the front
settings so the boom is resting on the front as well as
rear brackets.
WARNING! The max. transport height must never
exceed 4.0 m (13.1 ft.). Always measure the actual
total height and choose settings not exceeding 4.0 m.
Fig 4
EAGLE (SPB / SPC)
Suspension (SPC only)
The SPC boom features adjustable suspension for
24-28 m booms and 30 m booms.
The spring A has two assembly positions as shown on
the illustration below.. Position 1 is meant for 24-28 m
booms and position 2 is meant for 30 m booms.
Please ensure that the setup of the suspension
corresponds to the actual boom width of your sprayer.
See
fig
below
Fig 5
BOOM
1 2
A
T212-0019
7