Panasonic PT-47X54J Service Manual page 243

26. Begin adjustment from the center to the edge of the screen (see
figure)
27. Adjust to make distribute lines
LINE, POINT, ORIG. POINT modes, possible locations for cursor
28. Then press "1 or 3" on the remote until red and green appears.
NOTE:
Since convergence adjustment will not allow to adjust every single cross section of the grid, it is
very important to adjust, so that overall looks best, in "FINE" mode press "4" frequently on
remote control tocycle crosshatch pattern to verify convergence.
29. Perform adjustments for red so that red overlaps green, do not
move green.
30. Press "1 or 3" on the remote until yellow (red and green) and blue
appears, do not move green or red.
31. Perform adjustments so that blue overlaps Yellow (red and
green).
32. Press "1 or 3" key on remote to display red, green and blue
(white).
"LINE" mode adjustment
73