4. Tilt the assembly forward while lifting it out of place.
CAUTION:
At this point the keyboard, A/V inputs and convergence sensors,
must be disconnected from K-board and G-board, otherwise the
cables and connectors could get damaged.
Screen assembly
1. Remove the screen frame. See screen frame removal procedure
above.
2. Place screen frame face down on a soft surface.
3. If necessary remove G-board and/or K-board.
4. If necessary disassemble A/V panel removing the screws (4) and
tilt the panel upwards and release it from screen frame.
5. Remove the screws from the screen frame (20), be careful not to
damage the convergence sensors (see picture).
Screen frame removal (back view)
Screen assembly (Inside view)
19