Table of Contents
Advertisement
Some tie wraps that secure the wire dressings may need to be unfastened for chassis removal.
3. Remove plug connector in A6 that goes to G-Board (G1).
4. Remove plug connectors in A7, A8 that goes to K-board (K1) and R
-board (R1).
D-Board
1. D-Board is secured to the chassis tray with five screws.
2. The D-Board is mated to A-Board by four connectors (female side
of connectors): D1, D2, D3 & D4. To remove this board, unplug the
connectors on the A-Board pulling from the sides of each
connector.
NOTE:
Some tie-wraps that secure the wire dressings may need to be unfastened for chassis removal.
DC-Board
1. Plugs onto the D-Board at the D21, D22 and D23 (DC1, DC2 and
DC3 respectively) connectors.
NOTE:
This board is non-serviceable. / When removing this board pull carefully.
R-Board
1. This board is secured to the upper front side of the light box by
one screw, and plugged to R1 connector from A7 on A-Board.
LR, LG and LB Board
1. Each board is plugged into the socket on the PRT neck, LR-Board
on red PRT, LG-Board on green PRT and LB-Board on blue PRT.
33
Hide quick links:
Advertisement
Table of Contents
