Panasonic PT-47X54J Service Manual page 242

14. Enter to POINT "G-POINT" (for green) mode by pressing TV/
VIDEO.
15. "POINT" mode allows to move line horizontally and vertically
from the perimeter of cursor making rounded lines become
straight
16. In "POINT" mode, the adjustment data changes by 2 steps, See
values on screen by pressing RECALL on remote
17. When the cursor is located in the outer area of the border the
cursor starts to flash from one side to other, the location is for the
non-visible area and the most outer side of screen (inside the
ovals area, see figure); This applies to "LINE", "POINT" &
"ORIGIN.POINT" modes.
18. Begin adjustment from the center to the edge of the screen
19. Adjust to make lines as much straight as possible
20. When slightly adjustment is needed, use "ORIG. POINT" mode.
21. To enter to "G-ORIG. POINT" (for green) mode press TV/VIDEO.
22. With "ORIG. POINT", the adjustment data changes by 1 step, this
allows more detail in the adjustment. Display values on screen by
pressing RECALL on remote
23. Confirm that green adjustment is good enough, if adjustment is
not satisfactory, repeat adjustments.
24. Enter to LINE "G-LINE" mode by pressing TV/VIDEO.
25. LINE mode allows to move each single line horizontally and
vertically (see figure)
"POINT" & "ORIG. POINT" mode adjustment
72