Table of Contents
Advertisement
Solving Image Problems
g g Related Links
• "Changing the Image Aspect Ratio"
• "Projector Installation Settings - Installation Menu"
• "Resizing the Image with the Zoom Feature"
Adjusting an Image that Contains Noise or Static
If the projected image contains electronic interference (noise) or static, try the
following steps until the problem is solved.
a
Check the cables connecting your video source to the projector. They
should be:
• Separated from the power cord to prevent interference
• Securely connected at both ends
• Not connected to an extension cable
b
Adjust the Noise Reduction, MPEG Noise Reduction, and
Deinterlacing settings in the projector's Image menu.
Image > Image Enhancement > Noise Reduction
s
Image > Image Enhancement > MPEG Noise Reduction
s
Image > Image Enhancement > Deinterlacing
s
c
If you adjusted the image shape using the projector controls, try
decreasing the Sharpness setting in the projector's Image menu to
improve image quality.
d
Make sure you selected the correct Signal Format or EDID setting in
the projector's Signal I/O menu.
Change the HDMI IN EQ Level setting in the projector's Signal I/O
e
menu.
f
If you connected an extension power cable, try projecting without it to
see if it caused interference in the signal.
p.45
p.79
p.42
g
If you are projecting from a computer, select a computer video
resolution and refresh rate that are compatible with the projector.
h
If you connected an A/V system that does not support eARC/ARC to
the HDMI2 (eARC/ARC) port, the image may be distorted.
g g Related Links
• "Image Quality Settings - Image Menu"
• "Input Signal Settings - Signal I/O Menu"
Adjusting an Image with Incorrect Brightness or
Colors
If the projected image is too dark or bright, or the colors are incorrect, try the
following steps until the problem is solved.
a
Press the [Color Mode] button on the remote control to try different
color modes for the image and environment.
b
Check your video source settings.
Adjust the available settings in the projector's Image menu for the
c
current input source, such as Brightness, Contrast, Tint, Color
Saturation, and RGBCMY.
Make sure you selected the correct Dynamic Range setting in the
d
projector's Signal I/O menu.
e
Make sure you selected the correct Signal Format or EDID setting in
the projector's Signal I/O menu.
f
Make sure all the cables are securely connected to the projector and
your video equipment. If you connected long cables, try connecting
shorter cables.
114
p.75
p.77
Advertisement
Table of Contents
