Replacing The Fuses - Yamaha 135LC 2022 Owner's Manual

Periodic maintenance and adjustment
battery tends to discharge more quick-
ly if the vehicle is equipped with op-
tional electrical accessories.
NOTICE
To charge a VRLA (Valve Regulated
Lead Acid) battery, a special (con-
stant-voltage) battery charger is re-
quired. Using a conventional battery
charger will damage the battery.
To store the battery
1. If the vehicle will not be used for
more than one month, remove the
7
battery, fully charge it, and then
place it in a cool, dry place.
NOTICE: When removing the
battery, be sure to turn the main
switch off, then disconnect the
negative lead before discon-
necting the positive lead.
2. If the battery will be stored for
more than two months, check it at
least once a month and fully char-
ge it if necessary.
3. Fully charge the battery before
installation. NOTICE: When in-
stalling the battery, be sure to
turn the main switch off, then
connect the positive lead before
connecting the negative lead.
[ECA16842]
4. After installation, make sure that
ECA16522
the battery leads are properly con-
nected to the battery terminals.
NOTICE
Always keep the battery charged.
Storing a discharged battery can
cause permanent battery damage.
[ECA16304]

Replacing the fuses

2
3
4
ECA16531
1. Fuse box
2. Main fuse
3. Terminal fuse
4. Signal fuse
5. Spare fuse
The fuse box is located under the seat.
(See page 4-12.)
If a fuse is blown, replace it as follows.
1. Turn the main switch off and turn
2. Remove the blown fuse, and then
7-30
5
off all electrical circuits in ques-
tion.
install a new fuse of the speci ed
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
EAU93881
1