Rear Wheel - Yamaha 135LC 2022 Owner's Manual

Periodic maintenance and adjustment
wheel and brake disc have been
removed, otherwise the brake
pads will be forced shut.
To install the front wheel
1. Lift the wheel up between the fork
legs.
2. Insert the wheel axle, and then in-
stall the axle nut.
3. Take the motorcycle off the cen-
terstand so that the front wheel is
on the ground.
4. Tighten the axle nut to the speci-
ed torque.
7
Tightening torque:
Axle nut:
40 N·m (4.0 kgf·m, 30 lb·ft)
TIP
When tightening the axle nut, hold the
wheel axle with a wrench to keep it
from turning.
5. While applying the front brake,
push down hard on the handle-
bars several times to check if the
front fork compresses and re-
bounds smoothly.

Rear wheel

[ECA11073]
To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the locknut and drive
chain slack adjusting nut on each
side of the swingarm.
2. Loosen the axle nut and the brake
caliper bracket bolt.
1
1. Axle nut
2. Drive chain slack adjusting nut
3. Locknut
EAU25081
EAU66621
EWA10822
1
1. Rear wheel
2. Wheel axle
3. Brake caliper bracket bolt
4. Brake caliper bracket
3. Place the motorcycle on the cen-
4. Remove the axle nut.
5. Push the wheel forward, and then
TIP
The drive chain does not need to be
disassembled in order to remove and
install the rear wheel.
2 3
6. While supporting the brake caliper
7-34
4
2
terstand.
remove the drive chain from the
rear sprocket.
and slightly lifting the wheel, pull
the wheel axle out.
3