Midea DSK70035-J Instruction Manual

Midea DSK70035-J Instruction Manual

Instant electric water heater

Advertisement

The diagram above is just for reference. Please take the
appearance of the actual product as the standard.
Instant Electric Water Heater
Instruction Manual
Model:
DSK70035-J
Thank you very much for purchasing our water heater.
Before installing and operating your water heater, please
read this manual carefully and keep it for future reference.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DSK70035-J and is the answer not in the manual?

Questions and answers

Summary of Contents for Midea DSK70035-J

  • Page 1 Instant Electric Water Heater Instruction Manual Model: DSK70035-J Thank you very much for purchasing our water heater. Before installing and operating your water heater, please read this manual carefully and keep it for future reference.
  • Page 2: Table Of Contents

    Sincerely thank you for selecting our electric water heater. Please read this manual carefully before use; correctly grasp the methods for installation and use of this electrical water heater, to make full use of its excellent performances. Please do preserve the instruction manual for future reference.
  • Page 3: Cautions

    1. CAUTIONS To prevent personal injury, injury to others and property damage, the instructions below must be followed. Incorrect operation due to failure to follow instructions will cause harm or damage. Special Cautions ● This water heater is for household, and it can be installed wherever place that need hot water. ●...
  • Page 4: Product Introduction

    This manual is applicable to the instant electric water heaters (DSK *** *-*) manufactured by this company. The nomenclature of the product is complied according to the Chinese standard. 2.2 Technical Performance Parameters Model DSK70035-J Rated Voltage 220-240V~ Rated Frequency 50/60Hz...
  • Page 5: Unit Installation

    2.3 Brief introduction of pruduct structure DSK67035-J (Note:All dimensions are in mm) 2.4 Internal Wire Diagram 110V/220V~ ① Terminal block / ② Thermal cut-out / ③ Microswitch / Switches: (0- Off 1- LOW 2- Medium 3- High) / ④ ⑤ Heating elements INSTALLATION OF ELECTRICAL SCHEMATICS 3.
  • Page 6 3.2 Power Cord Installation ● It is necessary to increase wire section, if the water heater and electric cable itself are located on a thermally insulated or heating wall. ● The water heater shall be connected to the electric mains stationly (exept DSK***35-J). ●...
  • Page 7 NOTE The film exists respectively at the two side of the upper enclosure. A user can get rid of one film according to the indicated arrows by scissors. Remove the film at the power cord’s entrance on the opposite of the upper enclosure and ②...
  • Page 8: Methods Of Using

    Correct assembly Wrong assembly water inlet valve Valve (should be assembled in inlet) water outlet water outlet (Fig.4) WARNING Metallic / chromed hose and conductive control valve shall not be used. 3.5 Water Supply finished After all the plumbing is connecting, open water inlet valve of the product and supply water to the unit to drain away air inside until there is stable water flow comes out from shower head.
  • Page 9: Maintenance

    5. MAINTENANCE ● This electric water heater should be installed at the place without sunshine or rain spray. Please cut off power supply if not use for long time. ● If long time no use the unit, check the water heater first before use. Make sure no filth in water inlet hose, water outlet hose and sprayer,electrify after the water flows out stably.
  • Page 10 The product is subject to change without notice. Please keep this manual properly.

Table of Contents