JRC JSS-2150 Instruction Manual page 126

Operation
Message
Error
File access failed.
Error
Invalid file.
Error
Keyboard I/F ROM checksum error.
Error
No folder exists.
Error
No response.
Error
Overcurrent has been detected at the USB
port.
Error
Register the 9-digit Self-ID in advance.
Error
Register this station's ID in advance.
Error
The antenna is not tuned correctly.
Tune to the frequency now?
Error
The attached USB device is not supported.
The DTE supports the USB memory only.
Error
The DTE failed to access to the file system.
Error
The DTE failed to print.
Error
The DTE failed to stop the USB drive.
Error
The DTE was unable
format. Please remove the USB memory.
Error
The file is too large.
4-60
to complete the
Buttons
The specified file cannot be used for
OK
any malfunction.
OK
The file is malformed and invalid.
Detected the keyboard I/F ROM
OK
checksum error.
OK A specified folder is not found.
The controller may be busy and
OK
returns no reply to the data terminal.
The attached USB device may be
OK
failure.
Own station ID (9digit selcal number)
OK is needed to call the station by the 9
digit selcal number.
Own station ID is needed to call the
OK
station in the telex mode.
The antenna is not tuned. Starts the
antenna tuning immediately?
Yes/ No
Yes:
No:
The data terminal detects the USB
OK
device except the USB memory.
The file system and the files are
OK
inaccessible now.
OK Printing is unavailable now.
OK The USB drive cannot be unmounted.
The data terminal failed to format the
OK USB memory, so remove the USB
memory.
The specified file cannot be opened
OK because of the file size beyond the
8kB.
Description
Tunes immediately.
Tuning is not needed.