Keystone Installation; Door Handle Installation; Door Installation - Napoleon HIGH COUNTRY NZ6000-1 Installation And Operating Instructions Manual

6.3

keystone installation

Secure the faceplate to the appliance, using the 12 screws
A.
supplied. Start all 12 screws, then tighten evenly.
6.4

door handle installation

RIGHT DOOR HANDLE (OPERATING)
- Insert the door rod through the round hole
of the latch ensuring the flat edge of the "D"
shaped hole points towards the hinges.
- Slide the end of the door rod through the bush-
ing at the top of the door as shown.
- Insert the handle shaft through the door and
the latch.
- Secure with 2 flat washers and a nut.
- Feed the handle through the handle spacer
and into the handle shaft.
See Note #1
LEFT DOOR HANDLE (FIXED)
- Insert the handle shaft through the door.
- Secure with a lock washer, 2 flat washers and
a nut.
- Feed the handle through the handle spacer
and into the handle shaft.
See Note #2
Note #1:
You may need to move washers to the other side of the
latch to obtain sufficient door seal.
Note #2:
The final angle of the left door handle should mirror the
right door handle in the closed position. Tighten the nut
to secure the left handle at the desired angle.
6.5

door installation

Place brass washers onto the faceplate hinge bushing (2 extra washers
are supplied in order to level the doors if needed).
Slide the door hinge pin into the faceplate hinge bushing.
To remove the doors, open them slightly and lift them out of the
faceplate hinge bushings.
Bushing
Door
Rod
Flat side of
"D" shape
Handle shaft
Flat side of
"D" shape
Handle Spacer
Latch
Handle
Nut
Flat
Washers
Handle
Shaft
Handle
Flat side
Spacer
of "D"
Lock
shape
Washer
Handle
W415-1501 / C / 10.11.17
25
EN
Nut
Flat Washers