Midea VCS38A13L Operation & Instruction Manual page 6

Install the filter core:
04.
After cleaning, put the filter into the dust cup and notice the direction of the arrow.
Load the filter cotton.
05.
Caution
1. The filter parts can be put back for use only after being cleaned and dried. It is recommended
to have sun exposure for 24 hours to ensure it is thoroughly dried.
2. All parts must be ensured to be properly installed, otherwise it will cause product failure.
3. Water is not allowed to penetrate into the vacuum cleaner electrical components, or otherwise
may cause product failure.
10
Note the arrow direction
TROUBLESHOOTING
In case of malfunction, please refer to the following table
Problem Possible reason
The vacuum
- The power plug is not properly plugged into
cleaner does not the socket
work - No electricity on the power socket
- The vacuum cleaner switch is not turned on
- Motor thermal protector acts
Suction becomes - The main brush or accessories are clogged
weaker - Dust in the dust barrel is too full
- Dust in the dust cup filter cotton is too much
If the problem still can't be solved, please contact local service center.
Solution
- Reinsert the plug
- Check the circuit breaker
- Press the machine's power switch
- Unplug the plug and wait for the thermal protector
to recover
- Clean up the stemming
- Timely clean up garbage
- Clean the filter cotton
11