Appendix A • Specifications, Part Numbers, Accessories; Specifications; Video Input; Video Output - Extron electronics SW DVI A Series User Manual

Specifications, Part Numbers, Accessories

Specifications

Video
Video amplifier bandwidth ......... 1.65 Gbps
Pixel clock frequency .................... 24 MHz to 165 MHz
Impedance...................................... 100 ohms
Resolution....................................... Up to 1080p (HDTV) or 1920x1200

Video input

Number/signal type..................... 2 or 4 single link DVI-D digital component
Connectors ..................................... 2 or 4 female DVI-I
Nominal levels
Digital video ...................... 1.2 Vp-p
DDC (Display Data Channel)
Equalization ................................... +6 dB or +12 dB, switch selectable for each

Video output

Number/signal type..................... 1 DVI-D digital component video,
Connectors ..................................... 1 female DVI-I
Audio
Gain ................................................. Unbalanced output: +0dB;
Frequency response ...................... 20 Hz to 20 kHz, ±.05 dB
THD + Noise .................................. 0.01% @ 1 kHz at nominal level
S/N.................................................. >90 dB at maximum output (unweighted)
Crosstalk......................................... <-45 dB @ 20 kHz;
Stereo channel separation ............ >80 dB @ 20 Hz to 20 kHz
A-2 SW DVI A Series • Specifications, Part Numbers, Accessories
(highest resolution of the single link DVI
standard @ 60 Hz)
video, 1920x1200 @ 60 Hz maximum
resolution
TTL: 5.0 Vp-p
input
1920x1200 @ 60 Hz maximum resolution
Balanced output: +6 dB
-72 dB @ 1 kHz or below
Audio input
Number/signal type..................... 2 or 4 stereo, unbalanced
Connectors ..................................... (2 or 4) 3.5 mm mini audio jacks
Impedance...................................... >10k ohms unbalanced, DC coupled
Nominal level ................................ -10 dBV (316 mVrms)
Maximum level.............................. +8.2 dBV, unbalanced at 1% THD+N
N
0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0dBV
Audio output
Number/signal type..................... 1 stereo, balanced/unbalanced
Connectors ..................................... (1) 3.5 mm captive screw, 5-pole
Impedance...................................... 50 ohms unbalanced, 100 ohms balanced
Maximum level (Hi-Z) ................. >+16.5 dBu, balanced;
Maximum level (600 ohm)........... >+10.4 dBm, balanced;
Control/remote
Serial control port.......................... (1) RS-232, 3.5 mm captive screw
Baud rate and protocol ................. 9600 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configurations. 1= TX, 2 = RX, 3 = GND
Contact closure .............................. (1) 3.5 mm captive screw connector, 5-pole
Contact closure pin configurations
IR remote control........................... IR 102 Remote Control
Program control............................. Extron's Simple Instruction Set (SIS
General
External power supply ................. 100 VAC to 240 VAC, 50/60 Hz, external;
Power input requirements ........... 12 VDC, 0.7 A
Temperature/humidity ................ Storage: -40 to +158 °F (-40 to +70 °C) /
Cooling ........................................... Convection, no vents
SW DVI A Series • Specifications, Part Numbers, Accessories
(tip = L, ring = R, sleeve = GND)
2dBu
>8.2 dBV, unbalanced at 1% THD+N
7.1 dBm, unbalanced at 1% THD+N
connector, 5-pole (shared with
autoswitching control)
(shared with RS-232)
Pins 4 and 5 shorted together enable
autoswitch mode.
(#70-224-10, optional)
™
to 12 VDC, 1 A, regulated
10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) /
10% to 90%, noncondensing
)
A-3