Extron electronics SW DVI A Series User Manual page 14

Installation, cont'd
To enable autoswitching,
1. Cut a small piece of wire to use as a jumper.
2. Insert the ends of the wire into pin holes 4
and 5 of the provided 5-pole captive screw
plug, connecting pins 4 and 5 together. (See
the figure at right.)
3. Use an Extron Tweeker or other small
screwdriver to tighten the plug's two screws
above pin slots 4 and 5, so that the jumper
wire ends remain securely in place.
4. Insert the plug into the 5-pole captive screw
connector on the SW2/SW4 rear panel.
U T
T P
O U
T S
P U
Remote/Auto-Sw connector with pins 4 and 5
connected by a jumper
Autoswitching remains in effect as long as the jumper wires are
connecting the two pins together.
2-14 SW DVI A Series • Installation
S W
O -
U T
/ A
T E
M O
R E
T S
P U
I N 3
U T
2
T P
O U
1
1
4
2
SW DVI A Series
Chapter Three
3
Operation
Front Panel Features
Operations
Updating Firmware