Yamaha TW200 Owner's Manual page 76

Periodic maintenance and adjustment
according to the procedure in the
1
previous section "Supporting the
motorcycle".
2 4. Remove the axle nut and the
washer.
5. Pull the wheel axle out.
3
6. Remove the spacer, speedometer
gear unit and the wheel. NOTICE:
4
Do not apply the brake after the
wheel and brake disc have been
removed, otherwise the brake
5
pads will be forced shut.
6
To install the front wheel
1. Install the spacer into the right side
7
of the wheel hub.
2. Install the speedometer gear unit
into the left side of the wheel hub
8
so that the projections mesh with
the slots.
9
10
11
12
1. Speedometer gear unit
[ECA11073]
3. Lift the wheel up between the fork
legs.
TIP
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
1
1. Speedometer gear unit retainer
2. Speedometer cable
7-39
1
4. Insert the wheel axle, and then in-
stall the washer and the axle nut.
5. Lower the front wheel so that it is
on the ground.
6. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
90 N·m (9.0 kgf·m, 66 lb·ft)
7. Connect the speedometer cable.
2