Yamaha TW200 Owner's Manual page 51

1
3
2
1. Oil filter element cover
2. Oil filter element drain bolt
3. Oil filter element cover bolt
5. Remove the oil filter element cover
by removing the bolts.
6. Remove the oil filter element and
O-rings.
2
1
1. Oil filter element
2. O-ring
7. Check the O-rings for damage and
replace them if necessary.
8. Clean the oil filter element with sol-
vent, and then install it.
TIP
Check the oil filter element for damage
and replace it if necessary.
9. Install the oil filter element cover by
installing the bolts and the drain
bolt, then tightening them to the
specified torques.
Tightening torques:
Oil filter element cover bolt:
10 N·m (1.0 kgf·m, 7.4 lb·ft)
Oil filter element drain bolt:
10 N·m (1.0 kgf·m, 7.4 lb·ft)
TIP
Make sure that the O-rings are properly
seated.
10. Clean the oil strainer with solvent,
and then check it for damage and
replace it if necessary.
2
11. Install the oil strainer, compression
spring, a new O-ring and engine oil
drain bolt, and then tighten the
drain bolt to the specified torque.
Periodic maintenance and adjustment
7-14
Tightening torque:
Engine oil drain bolt:
43 N·m (4.3 kgf·m, 32 lb·ft)
12. Refill with the specified amount of
the recommended engine oil.
Recommended engine oil:
See page 9-1.
Oil quantity:
Oil change:
1.00 L (1.06 US qt, 0.88 Imp.qt)
With oil filter removal:
1.10 L (1.16 US qt, 0.97 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE

In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
1
2
3
4
5
6
7
8
ECA11621
9
10
11
12