Table of Contents
Advertisement
Installation and Operation, cont'd
Start auto image
Auto imaging allows you to "auto size" and "auto center" the selected image to
fill the screen. The processor measures the sync frequencies of an incoming video
source and uses an internal table to set the active image area, total image area, and
the sampling frequency.
If an unknown input is connected to the DVS 304, the processor measures and
estimates the resolution of the incoming video.
To turn on this feature, select the Advanced Config menu and choose "On".
Start auto imaging on a selected input by pressing "Next" after the Start Auto
Image menu.
Figure 2-10 — Start auto image menu
N An input with a vertical refresh rate less than 40 Hz will have to be manually
Input configuration
The following flowchart provides an overview of the Input Configuration
submenus and the options for each setting.
START AUTO
IMAGE ON IN1
MENU
INPUT
INPUT 2
NEXT
CONFIG
YUVi
Input 1 can only accept
composite video. Input 3
can only accept S-video.
Only Inputs 2 and 4 can
be configured for
different video types,
Select video format
although an SDI input
• Composite
can be assigned to any
• S-video
input.
• YUVi
• YUVp
• YUV Auto
Displays only when applicable
FILM MODE
NEXT
<OFF> ON
Film mode
Turn On or Off for low
resolution devices.
Figure 2-11— Input Configuration menus
2-12
DVS 304 • Installation and Operation
Default Cycle
INPUT 1
2 sec.
COMPOSITE
1024 x 768@60
centered and sized, using H/V Start and H/V Active under the Input Config
menu. When a rate with a low vertical refresh rate (e.g. 720p 29.9 Hz) is applied
and an Auto Image command is issued, the DVS 304 will refer to default values
instead of performing a true Auto Image.
INPUT 4
NEXT
NEXT
RGB SCALED
Select video format
• Composite
• S-video
N
• RGBcvS
• YUVi
• YUVp
• RGB scaled
• RGB pass
• Auto detect
H ACTIVE V
NEXT
NEXT
XXX
XXX
Horizontal
Vertical active
active pixels
lines
Specify the
Specify the
width in pixels
height in lines of
Not for use with
of the active
the active image
YUVp or RGB
image area
area sampled.
inputs.
sampled.
2 sec.
START AUTO
OUTPUT
MENU
IMAGE ON IN1
PRESS NEXT
NEXT
TO START
Displays only when applicable
Displays only when applicable
SDI INPUT
SDI DE-INTER
NEXT
< * > 1 2 3 4
FIELD STNDRD
Assign SDI to Input #
• 1, 2, 3, 4, * (none)
N SDI De-interlacing options:
The SDI input signal can be
• Field Standard
assigned to any input. Once
• Field Flip
assigned to a specific input,
only an SDI signal can be
accepted on that input. SDI
can be disabled by
selecting the *.
Displays only when applicable
H
START V
TTLPIX PHASE
NEXT
50
33
XXXX
08
Horizontal start
Vertical start
Total pixels
Pixel phase
Select for the
Select for the
Specify the
Adjust the pixel
left edge of the
top edge of the
width in pixels of
sampling point
active video.
active video.
the total image
for a selected
area sampled.
input.
NEXT
ASPECT RATIO
NEXT
NEXT
4x3
Aspect ratio options
• 4 x 3
• 16 x 9
For YUVp or RGB input only
Advertisement
Table of Contents
