Page 1
D10 Engine Safety, Operation, Maintenance & Parts Manual 034630 Engine,10HP Yanmar rev A-D Safety is our #1 concern! Read and understand all safety information and instructions before oper- ating, setting up or maintaining this machine. April 2010 Form #1098 Used with LT15D10...
SECTION 1 ABOUT THIS MANUAL This manual is provided as a supplement to the equipment manufacturer’s manuals. This manual provides information specific to the use of this equipment on the Wood-Mizer sawmill. Refer to the sawmill oper- ® ator’s manual and manufacturer's manual before attempting to operate this equipment.
Operation Starting The Engine SECTION 2 OPERATION Starting The Engine DANGER! Ensure the blade is disengaged and all persons are out of the path of the blade before starting. Failure to do so will result in death or serious injury. DANGER! Operate your engine only in well ventilated areas.
Maintenance Safety SECTION 3 MAINTENANCE Refer to the manufacturer’s manual for maintenance intervals and procedures unless otherwise instructed in this manual. Fol- low the manufacturer’s recommendations for dusty conditions. This manual only provides information about additional procedures NOTICE or procedures to be performed at different time intervals than found in the manufacturer's manuals.
Maintenance Fuel Filter Replace the pre-cleaner (element wrapper) every 2000 hours of operation. See the engine manual for further instructions. Fuel Filter Replace the fuel filter every 100 hours of operation or as required for engine performance. RPM Adjustments WARNING! Remove the blade before performing any engine service.
Replacement Parts Throttle/Clutch Assembly Throttle/Clutch Assembly 150101F DESCRIPTION (♦ Indicates Parts Available in Assemblies Only) PART # QTY. PLATE, KEY SWITCH MOUNT 034813 SHUT-OFF WELDMENT, THROTTLE LT15D 034808 BOLT, M6-1.0 X 40MM HEX HEAD F81001-5 NUT, M6-1.0 FREE NUT F81031-1 SPRING, EXTENSION 3/8 X 3 014818 BOLT, 1/4-20 X 1 HEX HEAD GR5...
Page 11
Replacement Parts Throttle/Clutch Assembly DESCRIPTION (♦ Indicates Parts Available in Assemblies Only) PART # QTY. BLOCK WELDMENT, LINKAGE CLUTCH/BRAKE 065572 PIN, 3/16 X 1 1/4 ROLL F05012-16 LINKAGE ASSEMBLY, W/BEARING 034605 NUT, 1/2-13 FREE HEX, ZINC F05010-35 WASHER, 1/2 SPLIT LOCK F05011-9 NUT, 1/2-13 JAM F05010-31...
Need help?
Do you have a question about the D10 and is the answer not in the manual?
Questions and answers