Siemens Clinitek Advantus Operator's Manual page 28

Symptom
Error 30 Analyzer
Error 31
Error 34
Error 36
Error 37
Error 50
Error 51
Error 52
Clinitek Advantus Operator's Guide
Possible Cause Remedy
Contact your local technical support
mechanical error provider.
Both areas of 1. Turn analyzer power off.
analyzer memory
2. Wait several seconds.
where factory
3. Turn analyzer power on.
calibration
parameters are 4. If the error repeats, contact your
stored are corrupt
Touch screen 1. Follow the instructions on the
calibration error
If the error repeats:
1. Turn analyzer power off.
2. Contact your local technical
Printer Error 1. Ensure that the external printer
2. Verify that both ends of the
3. Check that the printer has
Quality control Nearly 200 quality control result
results memory sets or nearly 500 patient result
(51) or sample sets are stored in memory and have
results memory not been transferred to a computer.
(52) is almost full
1. Ensure that the computer is
2. Ensure that the interface cable
3. Ensure that the setup
4. Transfer at least some of the
5. If unable to transfer records,
local technical support provider.
display to calibrate the touch
screen.
support provider.
is turned on and is online.
interface cable are securely
connected.
paper.
turned on.
is securely connected at both
ends
parameters for the computer
interface are correct.
records.
contact your local technical
support provider.
T
r o
u
b
l
e
s
h
o
o
t i
n
g
67