Alarm Input Recording - EverFocus 410M Instruction Manual

2. After enable an event, you need to set a time zone in the SCHEDULE SETUP MENU. An event
recording has to be included in a scheduled time zone. You can refer to SCHEDULE SETUP MENU
to set up a time zone which you would like to record when an event occurs.
3. When the event and schedule are set, you can enter the CAMERA SETUP MENUto set the event
recording speed (IPS) of a camera in the time zone you set.
Note: You can set the time zone from 00:00 to 00:00 daily in the SCHEDULE SETUP MENU, and set the
normal record speed as 0 IPS in the CAMERA SETUP MENU if you only need events recording
all the time.
4.4 ALARM INPUT RECORDING (Input trigger)
EDR810/410 provides a record function which is triggered by external signal via the 19
INPUT / OUTPUT port. When the record input signal is pulled low constantly, EDR810/410 will start to
record. The system will stop recording when the record input signal is not pulled low.
Note: Please check APPENDIX C to see other available alarm input/output functions.
61
th
pin of the ALARM