Day Time Running Lights; Fog Lights; Docking And Cornering Lights - PREVOST Le Mirage XL Owner's Manual

SAFETY
Note:
These instructions are also affixed to es-
cape hatch.
In the event of ventilation systems failure, hatch
can be used to provide air circulation, by simply
pushing hatch upwards.
Caution:
If running with roof hatch(es) open,
beware of low overhead clearances.
To relatch handle after use, push vent arms
upright in "full open vent" position, then insert
edge into bracket and pull handle in. Finally,
pull hatch inward, one side at a time.
1 .................................................................. Edge
2 ............................................................... Handle
3 ............................................................ Black tab
4 ...............................................................Bracket
5 ............................................................ Vent arm

Day Time Running Lights

This system turns on automatically the low
beams at a lower intensity as soon as engine is
started and parking brake is released.
This system will be canceled;
- when engine is stopped
- when parking brake is applied
- when the marker light switch is turned on.
Warning:
Never run vehicle at night with these
lights only as they have a lesser intensity, and
the system does not turn on the marker and
clearance lights.
Fog Lights (optional)
The halogen fog lights recessed in front bumper
allow the driver a better visibility in foggy
weather, and improve the range of vision just
ahead of vehicle. They are also a useful "active
safety" factor. For location of ON/OFF switch,
see page 2-14.
Note:
Some States or Provinces may restrict
the use of these lamps. Verify regulations gov-
erning each State and/or Province before using

fog lights.

Docking and Cornering Lights

(optional)
Two (2) halogen lights are installed on each side
of vehicle: one near the front and one near the
rear.
When the switch (see page 2-15) is set to the
"Docking" position, the four (4) lamps light
simultaneously in order to facilitate "docking"
procedure.
When the switch is set to the "Cornering"
position and the left or right turn signal is
selected, the corresponding cornering light will
illuminate to increase lateral visibility.
18052
3 - 4