How To Replace The Vaccum Pump Oil - TEXA KONFORT 700R Technical Manual

Proceed as follows:
1. Open the service flap.
2. Remove the dehydrator filter (see Dehydrator Filter Replacement chapter).
3. Locate the mechanical filter.
4. Unscrew the Rilsan pipe connection - mechanical filter, using a proper spanner
wrench.
5. Unscrew the constant expansion valve connection - mechanical filter, using a
spanner wrench n° 19.
6. Remove the filter.
7. Mount an O-ring on the new filter on the side of the constant expansion valve
connection.
8. Remount the filter using the specific tools and tightening with a torque of
approximately 17 Nm.

14.1.3 How to Replace the Vaccum Pump Oil

The oil in the vacuum pump must be replaced when you are prompted to do
so by the device.
You must carefully read and understand this Operating Manual in
order to perform the provided instructions correctly.
KONFORT 710R / 710L / 712R/ 720R / 760R / 760R BUS / 780R BI-GAS
1. Vacuum pump
2. Filler cap
3. Oil drain cap*
4. Pump oil level inspection
en
67