Unwrapping The Device; Gas Kit Installation - TEXA KONFORT 700R Technical Manual

8.1 Unwrapping the Device

This chapter describes the instructions for unwrapping/unpacking the device.
Perform the described operations with extreme care and on a flat
surface in order to avoid the device from tipping over.
Proceed as follows:

8.2 GAS KIT installation

This chapter describes the procedures that need to be carried out in order to
install the GAS KIT.
The fittings of the kit have been designed so that they can only be installed on
the mini manifolds they have been intended for.
Eg.: the HP quick fitting for the R134a refrigerant can only be installed on its
specific manifold and not, for instance, on the LP mini manifold for the R1234yf
refrigerant.
When installing the kit remember that:
• RED: always indicates high pressure connection (HP)
• BLUE: always indicates low pressure connection (LP)
1. Remove the GAS KIT.* **
2. Remove the cardboard.
3. Remove the bands that fasten the device to the pallet.
4. Remove the device from the pallet.
5. Unlock the wheels.
6. Make sure the device is in good condition and that it has
not been tampered with and/or damaged.
7. Make sure no parts are missing.
(*) Not required for the charging station model 780R BI-
GAS.
(**) Already installed on the charging stations:
• 705R
• 705R OFF ROAD
• 707R
• 710R
• 710L
en
47