Western HTS Mechanic's Manual page 10

INSTALLING STAND SHOE AND RECEIVERS
STAND SHOE
INSTALLATION
A fi nal adjustment of stand shoe
will be made after attaching
snowplow to vehicle.
1. Do not cut the spring tie until
after fi nal stand shoe adjustment.
2. Slide the stand shoe into the
stand tube and align the 1/4" hole
in the stand tube with the
1/4" hole in the stand shoe, third
hole from the bottom.
3. Insert 1/4" roll pin.
Do not cut
spring tie
Roll Pin
Install roll pin,
third hole from
the bottom
Lit. No. 41467, Rev. 01
4. Pull and hold the lock pin out;
then rotate the handle DOWN
and release the lock pin. It must
lock into the LOWER hole. Push
down on top of the shoe. The
shoe will be on the ground.
5. Remove the support block from
under the main A-frame tube.
RECEIVER INSTALLATION
1. Before assembling the receiver
to the vehicle undercarriage,
determine if the height
adjustment plate kits are needed.
2. Prior to measuring the vehicle
undercarriage height, the
undercarriage must be installed,
and ballast must be installed if
required. Park the vehicle on
a level surface. Measure the
distance from the ground to the
center of the receiver pin hole on
the undercarriage.
Center of
Receiver Pin Hole
X
Refer to the chart below to
determine if height adjustment
plates are required.
3. Use dimension "X" from Step 2
and follow the chart below:
Height Adjustment Plate
Selection Chart
Height
Dimension Adjustment Plate
"X" Kits Required
13.0"–15.5" No
15.5"–17.5" Yes
April 15, 2021
10