Western HTS Mechanic's Manual page 31

HAND-HELD MASTER CONTROL FOR THE SECURITY GUARD™ Snowplow Anti-Theft System
WARNING
To prevent accidental
movement of the blade,
always push the ON/OFF
button to switch the control
OFF whenever the snowplow
is not in use. The power
indicator light will turn OFF.
UNIVERSAL CLEAR
SECURITY
Perform the following steps to unlock
and clear an established security
code, without using the original
control that was used to establish the
code. This procedure should be used
to reset the module if the security
code is unknown.
IMPORTANT: The following
steps must be performed using
the Distributor Master Control
(PN 78800). Only the Distributor
Master Control can clear an
established code within a snowplow
module without using the original
control used to establish the code.
Lit. No. 41467, Rev. 01
1. Turn the vehicle ignition to the
"OFF" position.
2. With the control power OFF,
using the tool that was included
in the Distributor Master Control
box, place the tool over the
keypad and push down on the
plate.
NOTE: The only button that
should be exposed is the LOWER
button. All other buttons should
be engaged and pressed down.
3. While pushing down on the tool
engaging all functions except
LOWER, turn the ignition ON.
4. Upon turning the ignition to
the "ON" position, the module
has been reset, and there is no
security code associated with the
snowplow.
Align the plate so that
only the LOWER button
on the keypad is exposed.
LOWER Button
Master Control
Plate
FLOAT ON/OFF
AIS
LOWER
LOWER Button
Master Control
Plate
Position the
Master Control Plate
over the keypad.
Keypad
Master Control
Plate aligned
on the keypad.
April 15, 2021
31