Western HTS Mechanic's Manual page 15

OPERATIONAL TEST AND FINAL ADJUSTMENT
FINAL INSPECTION AND
ADJUSTMENT
1. Attach snowplow to the
vehicle mount. With snowplow
lowered to the ground and on
level pavement, measure the
dimension from the ground to the
bottom of the A-frame side tube.
This dimension must be 8-1/2" to
10-1/8".
2. With the snowplow attached and
on the ground, place the stand
arm in the lower position with
the lock pin engaged and with
the stand shoe fully retracted
in the "UP" position. Measure
the distance from the ground
to the bottom of the stand
shoe. This distance should be
1-3/8" to 2-1/8". The stand can
be adjusted to achieve this
dimension by removing the roll
pin and selecting the proper hole
in the stand stem. When the
stand height is correct, cut and
remove the spring tie.
Lit. No. 41467, Rev. 01
3. Fully angle the blade in both
directions in raised and lowered
positions. Adjust hose fi ttings,
wraps, and clamps so that hoses
do not contact vehicle bumper,
have no sharp bends, and are
wrapped at contact points with
the lift and A-frames.
Roll Pin
Stand
Shoe
Stand Arm
Stand Shoe
Stand
Arm
8-1/2" to 10-1/8"
1-3/8" to 2-1/8"
15
April 15, 2021