Western HTS Mechanic's Manual page 24

HAND-HELD CONTROL with SECURITY GUARD™ Snowplow Anti-Theft System
Smooth Stop
The control automatically allows
the blade to coast to a stop when
the button is released. This results
in smoother operation, reduces the
shock to the hydraulic system, and
increases hose and valve life.
Control Functions
Raise, Lower, Float, Angle
The four diamond-shaped buttons
in the center of the control face,
when pressed, will result in the blade
movements described in the table.
Lit. No. 41467, Rev. 01
Float Light
(green)
FLOAT ON/OFF
RAISE
1 2
L R
3 4
LOWER
Function Description of Operation
Press this button to raise the snowplow and
RAISE cancel the FLOAT mode. Function times out
after 4.8 seconds.
Press this button to lower the snowplow.
LOWER Release the button to stop blade at desired
height.
Press the LOWER button and hold 3/4 second
to activate this mode. The FLOAT light in
the upper left corner of the control face will
illuminate. The blade will lower to the ground
surface and follow the contour of the surface
as it dips or raises. Function does not time out,
FLOAT
but control will shut down after 20 minutes of
nonuse.
Press RAISE button momentarily to cancel
FLOAT. Angling left or right will not interrupt
(stop) the FLOAT function.
L
Press this button to angle the blade to the left.
(Angle
Function times out after 9.6 seconds.
Left)
R
Press this button to angle the blade to the
(Angle
right. Function times out after 9.6 seconds.
Right)
Used to access the SECURITY GUARD
1 & 4
system activation mode.
Used to clear the entered SECURITY GUARD
2 & 3
system code.
NOTE: If control function times out before desired
blade movement is complete, release button and
press again.
24
April 15, 2021