Western HTS Mechanic's Manual page 12

NIGHTHAWK™ HEADLAMPS
HEADLAMPS
WARNING
Your vehicle must be
equipped with snowplow
headlamps and directional
lights.
Headlamps, hardware, and
instructions are found in the
headlamp box. Additional hardware
is found in the loose parts box.
Headlamp Harness
Grommet
Plow
Battery
Cable
Lit. No. 41467, Rev. 01
Cable Ties
Refer to fi gure above for the following
instructions.
1. Remove the zip ties securing
light bar to lift frame.
2. With the wire harness behind the
lift frame, attach the headlamps
to the hole and slot in the light
bar by following the instructions
included with the headlamps.
3. Insert seven cable tie anchors
into 1/4" holes on the rear of
light bar from the inside, with the
locking tabs horizontal.
4. Install a split rubber grommet
on each headlamp wire 3" from
headlamp and insert grommet
and wire into slot on rear of light
bar.
5. Route the wires underneath
the light bar, behind the vertical
supports, and down along the
inside of the driver-side vertical
support, securing the wires to the
anchors with cable ties.
April 15, 2021
12