Pull-Up Bar Assembly - PRx Performance Build Limitless Full Cage-95 Assembly Instructions Manual

Full Cage Assembly Instructions
1. Once the crossmembers and uprights are assembled, attach the pull-up bar between the top
of the two front uprights (Figure 7).
2. Now that all components are assembled, make sure the spreader plate is flush to the floor
1. Once all your crossmembers and uprights are assembled, place your pull-up bar between the top of the
before anchoring rack to the floor.
two front uprights with the hardware provided as shown in Figure 7. *This procedure is the same for
3. Once rack is anchored to the floor, fully tighten all hardware.
all rack configurations.*
Note: Do not overtighten any of the bolts as this could result in deformed uprights.
2. Tighten all bolts, but BE CAREFUL not to overtighten as this could result in deformed uprights.
6
8
Figure 7

Pull-Up Bar Assembly

9
4
support@prxperformance.com
support@prxperformance.com 701-566-0452
Figure 8
7