Full Cage Assembly Instructions - PRx Performance Build Limitless Full Cage-95 Assembly Instructions Manual

Full Cage Assembly Instructions

1. First make sure all your components and hardware are accounted for, according to the Parts List on
1. Start with the back portion of the rack, making sure the logo is on the back side of the
page 3. Make sure you look under the correct configuration.
upright (Figure 1).
2. Start with the back portion of the rack, making sure the upright logo is on the back side of the upright.
2. When attaching the crossmembers, be sure to orient them correctly (see Min. and Max. in
(see figure 1)
Figure 1).
3. Assemble Frame. BE CAREFUL not to overtighten any of the bolts as this could result in deformed up-
3. Assemble frame and secure all hardware but do not fully tighten. NOTE: Do not
rights and make it difficult to further assemble any additional components. Make sure the bolts that
connect the spreader plate to the bottom of the uprights are only snug. Once you have all rack compo-
overtighten any of the bolts as this could result in deformed uprights and make it
nents assembled and square, you can make sure the spreader plate is flat on the floor and hardware
difficult to assemble additional components.
can then be tightened, so it does not become a trip hazard.
Figure 3
Start of Frame Assembly
support@prxperformance.com 701-566-0452
support@prxperformance.com
Logo on back side of rear uprights.
Min.
9
Max.
9
2
8
9
5
8
Figure 1
8
Figure 2
7
7
5
5