FS24X/FS20X DTM Manual, Issue 1
Length: 8 Characters of A-Z, 0-9, [SPACE] and a selection of special characters, e.g. +, -, <,
>. Default value is "????????"
"Long tag" is the tag used by HART Communication for a unique identification.
•
Functions exactly like Tag except the size is larger (max of 32 ISO Latin 1 characters). De-
fault value is "????????????????"
"Date" can be used to set a date, e.g. the date of installation or last inspection
•
"Write protect" (not writeable)
•
Descriptor" can be used to set a short text. Length is 16 characters, allowed characters are
the same as for "Tag". Default value is "????????????????"
"Message" can be used to set a short text. Length is 32 characters, allowed characters are
the same as for "Tag". Default value is "????????????????????????????????"
"PV Snsr s/n" (not writeable) is the serial number of the sensor
•
"Final Assembly number" can be used as a unique number, to identify the device
•
"Universal rev" (not writeable)
•
"Fld dev rev" (not writeable)
•
"Software rev" (not writeable)
•
Fourth "Tab": Review
5.3.4
The review menu shows all parameters of "Process variables", "Basic Setup" and "Detailed Setup" in a
plain list and protects them from being changed while viewed. This can be used to check if all settings
are done.
6
Offline parameterization function
In offline mode, the project can be prepared, created and stored without connected instru-
ments. Later, in online mode these data can be transmitted to the instruments ready for oper-
ation. Offline mode does not need any connection to the device.
The following pages describe the steps to offline parameterize an FS24X/FS20X device with
the DTM. At this time, it is presupposed that the DTM installation (§ 3.4) was already done.
27