3.3.12
Audio Connectors
TRSS Audio Jack
CN24
Pin
Signal
TIP
Headphone Out Left Channel
RING1
Headphone Out Right Channel
RING2
GND
SLEEVE
Mic In
Speaker Connector
CN47
Pin
Signal
1
SPKR_OUT+
2
GND
3
SPKR_OUT-
Amplified stereo speaker connector
CN55
Pin
Signal
1
AMP_OUT_LEFT+
2
AMP_OUT_LEFT-
3
AMP_OUT_RIGHT+
4
AMP_OUT_RIGHT-
since this interface is needed as an input to the amplifier.
SBC-D23
SBC-D23 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.0 - Author: S.B. - Reviewed by P.Z. - Copyright © 2021 SECO S.p.A.
On SBC-D23 board, audio functionalities are offered directly by the RK809 PMIC, which embeds a high
performance Audio Codec.
Always available on all factory configurations of SBC-D23 board, there is a TRRS Combo Audio
Socket CN24, i.e. a single socket which offer both stereo Line Out and Mic In functionalities.
Such TRRS Combo Audio socket can be used with any 4-poles 3.5mm diameter audio jack,
with pinout compatible with the most recent Headsets, shown in the table on the left.
Always available, there is also a dedicated 3-pin connector, type 53398-0371, for the connection of external
speakers (earphones)
Mating connector: MOLEX 51021-0300 receptacle with MOLEX 50079-8000 female crimp terminals.
SPKR_OUT+: Amplified speaker Positive Output
SPKR_OUT-: Amplified speaker Negative Output
As a factory option, the SBC-D23 board can be supplied with a TI TPA3110D2 Class-D amplifier,
offering stereo speaker output on a Micro-fit 2x2 connector type Molex 43045-0424 or equivalent, as
shown in the figure.
Mating connector: MOLEX 43025-0400 or equivalent with 43030 female crimp terminal
The power output available on this connector is dependent on the value of V
powered with a 24V voltage, it can reach up to 15W per channel on 8Ohm load @ 10% Total Harmonic Distortion
+ Noise (THDN+N)
Please be aware that the optional audio amplifier will exclude the headphone out (right and left) on TRRS connector,
Power rail. When the board is
IN
36