Advertisement
PHASE 2 – INSTALLATION
2.2 RANGER DESIGN INSTALLATION
2.2.2 • Place the Grab Handle to Ranger Design unit or panel.
• Mark the holes of the Grab Handle, then drill the mark using 3/8" drill bit.
• Install the Grab Handle to the Ranger Design unit or panel using Ranger Design fasyener kit.
For technical support, contact us at 1-800-565-5321
3/4"
NOTE: If you are installing the Grab Handle to Ranger design unit,
always place the Grab Handle 3/4" from the bend of the panel.
bend
TOOLS
q Cordless Drill
q Marker
q 3/8" Drill Bit
q Torque Gun
q 1/2" Socket
HARDWARE USED
2×
( 17 ft • lbs )
#90-486 Carriage Bolt
#98-114 Flat Washer
#98-109 Flat Washer
#94-116 Serrated Nut
6093-27 Installation Guide | REV. A1 | Page 7
5/16" × 3/4"
Advertisement
