Table of Contents
Advertisement
Available languages
Available languages
C- WIRING / INSTALLING
C- WIRING / INSTALLING
C1- Wiring diagram
Handset
1
2
3
4
5
6
From 0 to 50 metres: use 0.75 mm² cable
From 51 to 100 metres : use 1 mm² cable
C2- Attaching and connecting the elements
•
Attach the outdoor station at a height of 1.5 metres mounted on a flat wall.
•
Installation under a porch or a covered area is highly recommended.
•
Remove the bottom from the panel, slightly lift the flush-mounted unit then slide off the front panel.
•
Connect the outdoor station wire (as shown in the diagram below) and insert the outdoor station onto its support.
•
Attach the interior unit at a height of 1.5 metres on a flat wall. First fit the rear plastic support, connect the wires
and place the handset on its support.
•
Connect the interior unit.
•
Perform functional test before finalizing fixing of the elements.
After installing and testing, place a clear silicon seal on the top and sides of the outdoor station (not on the
bottom) to avoid any risk of infiltration.
6
EN
Outdoor station
1 2 3 4 5
From 0 to 10 metres :
use 1mm² cable.
155
Connecting cables
not provided
LOCK OR STRIKE : OPTIONAL
90
158
Advertisement
Table of Contents
