Edimax user guide Router User Manual page 26

Settings – Load Balance
•
Load Balance
Configuration
•
•
Click the "Update" button to save your changes.
NAT This section displays the current data about WAN 1 and WAN 2. You can use this
information to help you "fine-tune" the settings above.
Statistics
This section displays cumulative statistics.
Interface
Statistics
Use the "Restart Counters" button to restart these counters when required.
•
Buttons
•
•
Enable – Use this to enable your Load Balance settings. Unless this is
checked, the other settings on this screen have no effect.
Balance Type – Select the desired option:
•
Bytes rx+tx – Traffic is measured by Bytes.
•
Packets rx+tx – Traffic is measured by Packets.
•
Sessions established – Traffic is measured by Sessions.
•
IP Address – Traffic is measured by IP address.
Loading Share on WAN 1 – Enter the percentage (%) of traffic to be sent
over WAN 1. If one WAN port connection has greater bandwidth than the
other, the one with the greater bandwidth should be given a higher percentage
of traffic than the other.
Update – Save the settings on this screen.
Refresh – Update the data on screen.
Restart Counters – Restart the counters used in the "Interface Statistics"
section.
Page 22