Shark duo clean POWERFINS Vertex Pro ICZ300 Series Owner's Manual page 3

(Click)
(Click)
1
(Click)
(Click)
(Click)
4
1. Insert the Wand into the Floor Nozzle.
2. Insert the Handle into the wand.
3. Align the bottom of the Pod onto the rails on the neck of the floor nozzle. Slide the pod down the rails
until it clicks into place.
4. Connect the Hose to back of the pod, and attach the Hose Clip to the wand.
5. Charge the Battery completely before first use. With the handle toward the back, insert the battery into
the slot in the pod until it clicks into place.
IMPORTANT: For proper operation, ensure all connections are securely clicked into place.
s h a r kc l e a n . c o m
ASSEMBLY
(Click)
2 3
5
3 WAYS TO CHARGE THE LITHIUM-ION BATTERY
OUT OF VACUUM
SUCTION POWER MODES
SUCTION MODE ECO Mode
DISPLAY LIGHTS Maximum runtime.
Saves battery power.
Off
Deep Clean Mode
Best balance between
ECO
suction power and
optimized runtime.
Deep
Clean
Boost Mode
Maximum suction. Uses
Boost
the most battery power.
NOTE: Only one charger is provided.
NOTE: When using the cradle, insert the charger plug into the port and rotate to lock into place.
The battery will not charge unless the charger is locked into place.
NOTE: The battery must be charged before first use. A complete charge takes approximately 3.5 hours.
To remove the battery for charging, lift the handle
on top of the battery and pull up. The battery must
be charged before first use.
A complete charge takes approximately 3.5
hours.
IMPORTANT: When charging, connect the charger
to the port first, then plug the charger into wall
outlet.
IN CHARGING CRADLE
Battery Runtime
MODE MINUTES
Handle Only – ECO Mode 60
Bare Floor Mode – ECO Mode
40
Carpet Mode – ECO Mode
30
Boost Mode (Handle Only)
10
Suction mode impacts runtime. Use BOOST in
short bursts.
s h a r kc l e a n . c o m