Replacing Filters - Shark duo clean POWERFINS Vertex Pro ICZ300 Series Owner's Manual

MAINTENANCE
Your vacuum comes with a Pre-Motor Filter and Frame, and a HEPA Post-Motor Filter.
CLEANING PRE-MOTOR FILTER (ONCE A MONTH)
Regularly rinse and replace the pre-motor filter to maintain your vacuum's suction power.
IMPORTANT: To prevent damage, rinse filters with lukewarm water ONLY. DO NOT use soap. Allow filters to
air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electric parts.
Foam
Filter
Filter
Frame
s h a r kc l e a n . c o m
Filter
Door
1. Slide down Filter Door release button.
2. Tilt filter door and lift off.
3. Remove the filter and frame, then pull the foam
filter off the frame.
4. Rinse foam filter with lukewarm water ONLY
and leave to air-dry for at least 24 hours or until
completely dry.
5. Once completely dry, slide the foam filter back
onto the frame.
6. Holding the pull tabs, push the frame back
into the pod.
7. Reinsert bottom of filter door into slots on
pod. Tilt door to close, pressing until it clicks
into place.
MAINTENANCE
CLEANING HEPA POST-MOTOR FILTER (ONCE A YEAR)
Rinse and replace the HEPA post-motor filter every year to maintain your vacuum's suction power.
IMPORTANT: Rinse HEPA Post-Motor Filter with lukewarm water ONLY. DO NOT use soap. Allow to air-dry for
at least 24 hours or until completely dry before reinstalling. DO NOT scrub HEPA Post-Motor Filter.
HEPA
Post-Motor
Filter

REPLACING FILTERS

Follow the previous instructions for removing filters. The Foam Filter should be replaced every
2.5 years, and the HEPA Post-Motor Filter should be replaced every 3 years, subject to frequency of use.
Replacement Pre-Motor Filter
and Frame
NOTE: To order replacement parts and filters, visit sharkclean.com.
1. Pull up on HEPA Post-Motor Filter access
tab to remove.
2. Rinse filter with lukewarm water ONLY and
leave to air-dry at least 24 hours or until
completely dry before reinstalling.
3. When dry, reinsert HEPA Post-Motor Filter
and press down until it clicks into place.
Note: Battery must be removed before
HEPA Post-Motor Filter can be removed.
Replacement HEPA Post-Motor filter
s h a r kc l e a n . c o m