Emptying The Dust Cup; Replacing Filters - Shark Navigator Lift-Away ZU503AMZ Owner's Manual

EMPTYING THE DUST CUP

IMPORTANT: Unplug the power cord before performing any maintenance. Empty
the dust cup each time you vacuum and periodically during cleaning, when debris
in the dust cup reaches the MAX fill line.
To remove Dust Cup, slide up tabs on both sides
of dust cup handle. Tilt dust cup forward, then
lift to remove.
To remove collected debris from Lint Screen,
press top release button and lift handle to
open. Gently brush debris off the screen.
s h a r kc l e a n . c o m
Press lower release button to open bottom of
dust cup.
To reinstall, place bottom of dust cup into
pod and then tilt until it clicks into place.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
Regularly rinse and replace the filters to maintain your vacuum's suction power.
To prevent damage from cleaning chemicals, rinse filters with cold water only. Allow all filters
to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into
electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
Foam
Felt
CLEAN PRE-MOTOR FILTERS
EVERY 3 MONTHS
Remove Dust Cup, then lift out Filters.

REPLACING FILTERS

Follow the previous instructions for removing filters. The Pre-Motor Filter should be replaced every
2.5 years. The HEPA Filter should be replaced every 3 years.
Replacement
Pre-Motor Foam &
Felt Filter Kit
XFF350
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
Filter
Door
RINSE HEPA FILTER
EVERY YEAR
Remove dust cup, tilt Filter Door and firmly
pull it off. Press tab at top of HEPA Filter and
pull out filter. To reinstall, insert HEPA filter
into unit and replace the filter door.
Replacement
HEPA Filter
XHF350
s h a r kc l e a n . c o m