a
1
b
CHOKE CABLE INSTALLATION
1. Inspect:
NOTE:
1
Push the choke knob 1 entirely in before
installing it to the frame.
2. Install:
NOTE:
Place the choke knob casing cap against the
stay 3.
3. Install:
NOTE:
Place the carburetor choke valve in its fully
2
open position a, insert the tip of the inner
cable into the drum hole 5, and then secure it
3
in place with the screw 6.
5
6
a
4
SWL3420J
THROTTLE CONTROL MOTOR
1. Inspect:
NOTE:
• Install the shaft a of the throttle control
motor by aligning it with the groove b of the
throttle shaft.
• Install the throttle valve, and then make sure
that is moves smoothly.
SVU3840J
• When installing the engine, fully open the
throttle valve.
3-50
CARBURETOR
• Choke knob 1
• Casing cap (choke cable) 2
• Inner cable 4
Screw:
1.0 Nm (0.1 m · kg, 0.7 ft · lb)
• Throttle control motor 1
ENG